Pool report on parallel routes

Respondida

Peyman Panahi

• 30 de noviembre de 2018 04:17

Hi all, 

 

I am setting two routes to overlap each other but face an issue on the pool report. As you can see in the picture below I have set Pnt_powderline and Assembly_pull parallel and have closed the Fab_pull route. So I go the to the pool report only Fab_general should show. But I can see Fab_general, Pnt_powderline, and Assembly_pull routes all open at the same time. Technically it should show only Fab_general and not the other routes. I appreciate your help and insight on my problem. 

Vote

0

• 

  Yaremi Miranda Lopez

  • 5 de diciembre de 2018 14:11

  Hello Peyman,

  If you selected these operations as parallel, then it means that you can "work" on them at the same time and this is why you can see them in the pool report. 

  What is the result you want to achieve? Why are you defining this as parallel?

Iniciar sesión para dejar un comentario.